USG Sheetrock Paper-Faced Metal Bead and Trim - Manual (Page 8)

How to Install
Transition Caps
1 Position corner cap and tack
into place with one fastener
to allow for adjustment.
PG 7(1) Paper Faced Metal Bead and Trim Installation Guide Illustrations
How to Install Corner Caps
3
4 2
1
2 Slide corner bead over align-
ment tongue on each end of
corner cap. Be sure beads
align and seams are tight.
PG 7(1) Paper Faced Metal Bead and Trim Installation Guide Illustrations
How to Install Corner Caps
3
4 2
1
3 Fasten corner cap into per-
manent position and press
corner beads into place with
roller tool or damp sponge.
PG 7(1) Paper Faced Metal Bead and Trim Installation Guide Illustrations
How to Install Corner Caps
3
4 2
1
1 Measure distance between
floor and end of bead to
determine transition cap
length required.
PG 7(2 ) Paper Faced Metal Bead and Trim Installation Guide Illustrations
How to Install Corner Caps
1 3
2 4
2 Cut transition cap to appropri-
ate length.
PG 7(2 ) Paper Faced Metal Bead and Trim Installation Guide Illustrations
How to Install Corner Caps
1 3
2 4
3 Place joint compound on back
of transition cap and position
on the wall. Press tight.
PG 7(2 ) Paper Faced Metal Bead and Trim Installation Guide Illustrations
How to Install Corner Caps
1 3
2 4
4 Place corner bead over
transition cap tongue. Press
corner bead into place with
roller tool or wet sponge.
PG 7(2 ) Paper Faced Metal Bead and Trim Installation Guide Illustrations
How to Install Corner Caps
1 3
2 4
7
How to Install
Corner Caps