USG Plank and Large Panel Stabilizer Bars - Manual (Page 16)

IC592/rev 7-13
© 2013, USG Interiors, Inc.
Printed in U.S.A. Manufactured by
USG Interiors, Inc.
550 West Adams Street
Chicago, IL 60661
Product Information
See usg.com for the most
up-to-date product information.
Installation
Must be installed in compliance
with ASTM C636, ASTM E580,
CISCA, and standard industry
practices.
Code Compliance
The information presented
is correct to the best of our
knowledge at the date of
issuance. Because codes
continue to evolve, check
with a local official prior to
designing and installing a
ceiling system. Other
restrictions and exemptions
may apply. This is only
intended as a quick reference.
ICC Evaluation Service, Inc.,
Report Compliance
Suspension systems
manufactured by USG Interiors,
Inc., have been reviewed and
are approved by listing in
ICC-ES Evaluation Report 1222.
Evaluation Reports are subject
to reexamination, revision and
possible cancellation. Please
refer to usgdesignstudio.com or
usg.com for current reports.
L.A. Research Report
Compliance
D onn brand suspension systems
manufactured by USG Interiors,
Inc., have been reviewed and
are approved by listing in the
following L.A. Research Report
number: 25764.
Notice
We shall not be liable for
incidental and consequential
damages, directly or indirectly
sustained, nor for any loss
caused by application of these
goods not in accordance with
current printed instructions or
for other than the intended use.
Our liability is expressly limited to
replacement of defective goods.
Any claim shall be deemed
waived unless made in writing
to us within thirty (30) days from
date it was or reasonably should
have been discovered.
The following are trademarks of USG
Interiors, Inc. or a related company:
C
entriCitee , D onn , DXF, DXI, DXT, DXLT,
F ineline , i nDentitee , t rue W ooD , USG, USG
in stylized letters.
usg.com
seismicceilings.com
sustainableceilings.com
usgdesignstudio.com
Safety First!
Follow good safety/industrial
hygiene practices during
installation. Wear appropriate
personal protective equipment.
Read MSDS and literature
before specification and
installation.