Titus RAB IOM - Manual (Page 7)

RAB Installation Manual
IOM-RAB-00 08-15-04
7 of 10
11. Activate motor until blade reaches desired opening
and tighten the setscrew. Figure 11 shows setscrew
location.
7.
8. Use self-tapping screws to secure bracket.
Tighten the two nuts on the universal clamp with
8 mm wrench, 3-5 ft. lb. torque.
Note: Actuator compresses damper blades
upon reaching the end position creating an
airtight damper.
12. Slide the rain cover over motor and use sheet metal
screws to secure the cover.
tr e s n I . 3 1 . d e ri u q e r fi , s p o t s d n e t s u j d A . 9 filter in the bottom of the fresh air intake.
10. Wire motor as shown in Figure 10. 14. Restore power to system.
Figure 10. Wiring Diagram