Titus Atlas Operating Room Ceiling System (AORCS) - Manual (Page 5)

I N S T A L L A T I O N & O P E R A T I O N M A N U A L
Atlas Ceiling System IOM
Installation & Operation
AORCS
5
Trim the tees as necessary to ensure a tight fit and seal to the ceiling components connected to each other. A fine tooth carbide tip miter saw is
recommended for cutting ceiling tees. Proper Personal Protection Equipment (PPE) is required for cutting and installing the ceiling components. A
full face shield, ear protection and proper gloves should be worn for this procedure.
Tee Joint
Note: Trim tees to ensure a tight fit. Gaps and
out of square connections are not acceptable.