Bazooka – TapeTech T05CF Bazooka Continuous Flow Taper User Manual
Page 8

4. Align the valve so that the trigger lines up with the tape spool.
Secure by tightening the clamp nut.
© 2011 AMES TAPING TOOLS
7
5. The creaser trigger is attached to the valve using the clevis pin.
6. The range of the creaser trigger may be adjusted by threading the
nut in or out.
8. Install a roll of drywall tape onto the spool mount of the taper so
that it will unwind clockwise as you look at the roll.
9. Secure the roll by looping the keeper into the slot on the spool post
and inserting the anchor into the receptacle on the spool mount.
10. Feed the tape through the tape guide with the back side of the tape
facing away from you so that the curl of the tape will go over the
main wheel of the taper.
11. Advance a tab of tape over the main wheel of the taper.
BAZOOKA®
(cont’d)
7. The hose can now be connected to the open end of the valve, similar
to the way that the valve was attached to the taper.
Tape curls over
the taper wheel
Tape guide
- T8034 Bazooka CFS 34 Finishing Box Handle T8042 Bazooka CFS 42 Finishing Box Handle T8054 Bazooka CFS 54 Finishing Box Handle T8072 Bazooka CFS 72 Finishing Box Handle T14CF Bazooka CFS 42 Corner Finisher Handle CFFULL Cont. Flow Full Bundle CFFLAT Cont. Flow Flat Finishing Bundle CFCRNR Cont. Flow Corner Finishing Bundle T14EC Bazooka CFS 60 Corner Finisher Handle T20CF Bazooka CFS 7 Finishing Box (slimline) Bazooka T30CF Bazooka CFS 12 Finishing Box (slimline)