Corner tool handle – TapeTech T05CF Bazooka Continuous Flow Taper User Manual
Page 21

BEGIN ANGLES:
1. Fully squeeze the valve lever to start the flow of compound and
move the tool toward the other end of the joint.
2. Release the valve lever to stop the flow of compound about 3-6”
from the end of the joint.
3. Repeat for the next joint to be finished.
© 2011 AMES TAPING TOOLS
20
MAINTENANCE:
1. This tool must be thoroughly washed after each use. Flush the compound from the tool with water, either with
the pump or with a water hose and cleaning adapter.
2. External material can be sprayed off with a hose or removed with a cleaning brush.
TRAINING NOTE: For horizontal angles, you can run the joint around the entire room in the same direction. For
vertical angles, you should start at the floor and run the joint in one sweep to the very top.
CORNER TOOL HANDLE
(cont’d)
- T8034 Bazooka CFS 34 Finishing Box Handle T8042 Bazooka CFS 42 Finishing Box Handle T8054 Bazooka CFS 54 Finishing Box Handle T8072 Bazooka CFS 72 Finishing Box Handle T14CF Bazooka CFS 42 Corner Finisher Handle CFFULL Cont. Flow Full Bundle CFFLAT Cont. Flow Flat Finishing Bundle CFCRNR Cont. Flow Corner Finishing Bundle T14EC Bazooka CFS 60 Corner Finisher Handle T20CF Bazooka CFS 7 Finishing Box (slimline) Bazooka T30CF Bazooka CFS 12 Finishing Box (slimline)