Corner tool handle – TapeTech T05CF Bazooka Continuous Flow Taper User Manual
Page 19

The finishing process using the Bazooka® Continuous Flow Corner Tool Handle.
There are three important facts you should remember about the Bazooka® Continuous Flow Corner Tool Handle:
•
It eliminates lap marks because you only have to move along the joint in one direction.
•
It uses heaver joint compound, therefore there is less shrinkage and better coverage over the tape.
•
Unlike traditional corner tools that must be loaded and reloaded using a hand pump, Bazooka® Continuous Flow
can work continuously without having to stop and reload.
GENERAL:
1. The continuous flow corner tool handle is used to finish inside corners or to apply joint compound to outside
corners as part of the application of corner bead.
2. It works with existing Ames® corner tools.
3. The handle is used in conjunction with the inline mechanical valve.
© 2011 AMES TAPING TOOLS
18
4. Connect them by installing the quick disconnect pilot fitting into the
connection on the end of the handle.
CORNER TOOL HANDLE
- T8034 Bazooka CFS 34 Finishing Box Handle T8042 Bazooka CFS 42 Finishing Box Handle T8054 Bazooka CFS 54 Finishing Box Handle T8072 Bazooka CFS 72 Finishing Box Handle T14CF Bazooka CFS 42 Corner Finisher Handle CFFULL Cont. Flow Full Bundle CFFLAT Cont. Flow Flat Finishing Bundle CFCRNR Cont. Flow Corner Finishing Bundle T14EC Bazooka CFS 60 Corner Finisher Handle T20CF Bazooka CFS 7 Finishing Box (slimline) Bazooka T30CF Bazooka CFS 12 Finishing Box (slimline)