Flat finisher box – TapeTech T05CF Bazooka Continuous Flow Taper User Manual
Page 15

7. After selecting the proper width box and length of handle for the job,
the operator connects them by threading the box studs into the
wingnuts on the handle connector plate.
8. The wingnuts should be tightened snuggly by hand, but no tools need
to be used to provide a secure connection.
9. The hose is then connected by inserting the quick disconnect pilot
fitting of the hose into the grip end of the handle.
10. Secure by hand tightening the clamp nut.
© 2011 AMES TAPING TOOLS
14
FLAT FINISHER BOX
(cont’d)
No tools needed to
tighten wingnuts
Quick disconnect
pilot fitting
This manual is related to the following products:
- T8034 Bazooka CFS 34 Finishing Box Handle T8042 Bazooka CFS 42 Finishing Box Handle T8054 Bazooka CFS 54 Finishing Box Handle T8072 Bazooka CFS 72 Finishing Box Handle T14CF Bazooka CFS 42 Corner Finisher Handle CFFULL Cont. Flow Full Bundle CFFLAT Cont. Flow Flat Finishing Bundle CFCRNR Cont. Flow Corner Finishing Bundle T14EC Bazooka CFS 60 Corner Finisher Handle T20CF Bazooka CFS 7 Finishing Box (slimline) Bazooka T30CF Bazooka CFS 12 Finishing Box (slimline)