Troubleshooting tips – TapeTech T05CF Bazooka Continuous Flow Taper User Manual
Page 25

24
© 2011 AMES TAPING TOOLS
CORNER TOOL HANDLE
1. Too much joint compound on one side
• Tool needs to be centered in the angle to allow consistent pressure on each side.
• Center the tool to the angle - not your body.
• Corner finisher is worn - exchange for fresh tool at your local Ames® store location.
2. Tool drags and leaves marks
• Debris in and around the corner finisher.
• The corner finisher bisects the angle not your body (also known as tool operational positioning).
• The bend on the handle helps you apply pressure to the center of the corner finisher, when your body is not
positioned to do so.
3. Excess or insufficient joint compound flow
• The operator must ensure the proper amount of joint compound is dispensed by matching the speed of the
corner tool to the flow of material from the pump.
TROUBLESHOOTING TIPS
(cont’d)
- T8034 Bazooka CFS 34 Finishing Box Handle T8042 Bazooka CFS 42 Finishing Box Handle T8054 Bazooka CFS 54 Finishing Box Handle T8072 Bazooka CFS 72 Finishing Box Handle T14CF Bazooka CFS 42 Corner Finisher Handle CFFULL Cont. Flow Full Bundle CFFLAT Cont. Flow Flat Finishing Bundle CFCRNR Cont. Flow Corner Finishing Bundle T14EC Bazooka CFS 60 Corner Finisher Handle T20CF Bazooka CFS 7 Finishing Box (slimline) Bazooka T30CF Bazooka CFS 12 Finishing Box (slimline)