Flat finisher box – TapeTech T05CF Bazooka Continuous Flow Taper User Manual
Page 17

BOX OPERATION:
1. The Ames® Continuous Flow Flat Finishers can be used in a variety of ways. It’s possible to use these boxes very
much like traditional ATF flat finishers by using the pump between joints to keep the boxes supplied with
compound.
2. It’s also possible to use the pump only when the boxes are on the wall to actually help push the material out of
the box. Or any combination of the above may be used as well.
BEGIN FLATS:
1. Using the pump to maintain the mud supply in the box between joints is the easiest way to learn how to use the
tools for an operator that is proficient with current flat finisher boxes.
2. After finishing a joint with the box, the operator presses one of the triggers on the box slide controller to refill the
box with the appropriate amount of compound. The operator then positions to finish the next joint.
3. Using the pump while the box is on the wall takes advantage of the pump to help push the material out of the
box, but takes a bit more time to learn:
a. The operator must position the box slide controller so that he can actuate the trigger as desired while
moving the tool along the joint.
b. The speed of movement must also be coordinated with the speed of the pump so that the box doesn’t
run empty or fill up.
c. It is important that the finisher box be run about ½ full when operating the system in this way or finish
quality can suffer.
d. Also, the trigger should be released 6-12” from the end of the joint to allow for the gradual stoppage of
compound flow through the hose.
4. Thick edges on one side or both and/or streaks pulled in the direction of finish are indications that either box
speed should be increased and/or pump speed should be decreased.
5. Excess material on the bottom plate of the box can be indicative of a number of things: pushing harder than is
required, using compound thinner than optimum, holding the trigger too long, running the box too full.
© 2011 AMES TAPING TOOLS
16
FLAT FINISHER BOX
(cont’d)
- T8034 Bazooka CFS 34 Finishing Box Handle T8042 Bazooka CFS 42 Finishing Box Handle T8054 Bazooka CFS 54 Finishing Box Handle T8072 Bazooka CFS 72 Finishing Box Handle T14CF Bazooka CFS 42 Corner Finisher Handle CFFULL Cont. Flow Full Bundle CFFLAT Cont. Flow Flat Finishing Bundle CFCRNR Cont. Flow Corner Finishing Bundle T14EC Bazooka CFS 60 Corner Finisher Handle T20CF Bazooka CFS 7 Finishing Box (slimline) Bazooka T30CF Bazooka CFS 12 Finishing Box (slimline)