Bazooka – TapeTech T05CF Bazooka Continuous Flow Taper User Manual
Page 7

The taping process using the Bazooka® Continuous Flow Taper.
There are three important facts you should remember about the Bazooka® Continuous Flow Taper:
•
Current automatic taper users can move up to Bazooka® Continuous Flow with minimal training – the tools are
almost identical!
•
It simultaneously applies tape and joint compound to any wall joint and will cut the tape to the desired length.
•
Unlike traditional tapers that must be loaded and reloaded using a hand pump, Bazooka® Continuous Flow can
work continuously without having to stop and reload.
GENERAL:
1. The Bazooka® Continuous Flow Taper is designed to work with tape that is 2-1/16 to 2-1/8” wide. Wider tape will
bind and narrower tape may have a tendency to jam.
© 2011 AMES TAPING TOOLS
6
BAZOOKA®
2. The taper is used in conjunction with the inline mechanical valve.
3. Connect them by installing the quick disconnect pilot fitting into the
connection on the end of the taper.
Attach taper to inline
mechanical valve
- T8034 Bazooka CFS 34 Finishing Box Handle T8042 Bazooka CFS 42 Finishing Box Handle T8054 Bazooka CFS 54 Finishing Box Handle T8072 Bazooka CFS 72 Finishing Box Handle T14CF Bazooka CFS 42 Corner Finisher Handle CFFULL Cont. Flow Full Bundle CFFLAT Cont. Flow Flat Finishing Bundle CFCRNR Cont. Flow Corner Finishing Bundle T14EC Bazooka CFS 60 Corner Finisher Handle T20CF Bazooka CFS 7 Finishing Box (slimline) Bazooka T30CF Bazooka CFS 12 Finishing Box (slimline)