Bazooka – TapeTech T05CF Bazooka Continuous Flow Taper User Manual
Page 13

GOOSER NEEDLE REPLACEMENT:
1. The gooser needle is sharp and should always be handled with pliers.
2. While holding the pin that extends out of the needle holder, loosen
the clamp screw and remove the existing gooser needle with a pair
of pliers.
3. Insert some tape in the tape guide and then install the new needle
using a pair of pliers.
© 2011 AMES TAPING TOOLS
12
BAZOOKA®
(cont’d)
4. Gently press the needle into the tape so that the point slightly protrudes through the other side of the tape and
tighten the clamping screw. (Caution: You want the needle to grab the tape, however you do not want the
needle to pass through the tape) .
5. When installed properly, the needle should securely drive the tape forward when advancing, but fully release
from the paper when the gooser is at the top of its stroke and then skim over the top of the paper as it returns to
the bottom of its stroke.
- T8034 Bazooka CFS 34 Finishing Box Handle T8042 Bazooka CFS 42 Finishing Box Handle T8054 Bazooka CFS 54 Finishing Box Handle T8072 Bazooka CFS 72 Finishing Box Handle T14CF Bazooka CFS 42 Corner Finisher Handle CFFULL Cont. Flow Full Bundle CFFLAT Cont. Flow Flat Finishing Bundle CFCRNR Cont. Flow Corner Finishing Bundle T14EC Bazooka CFS 60 Corner Finisher Handle T20CF Bazooka CFS 7 Finishing Box (slimline) Bazooka T30CF Bazooka CFS 12 Finishing Box (slimline)