beautypg.com

Installation operating instructions, Automatic convection fan operation, Adjusting flame height – Regency Hampton H15 Small Gas Stove User Manual

Page 39: Operating instructions, Shutdown procedure, First fire, Lighting procedure

background image

Hampton® H15-1 Direct Vent Freestanding Gas Stove

39

39

INSTALLATION

OPERATING INSTRUCTIONS

AUTOMATIC

CONVECTION FAN

OPERATION

The fan operates automatically - turn the knob at
the top right rear corner to adjust to the desired
speed. The fan will turn on as the stove comes up
to operating temperature. After the unit has been
turned off and the unit cooled to below a useful
heat output range the fan will shut off automatically.

ADJUSTING FLAME

HEIGHT


Your heater has an adjustable fl ame to tailor the
look and heat output to your specifi c needs. It is
adjusted by turning the fl ame adjustment dial on
the gas control valve.

Turn clockwise to adjust the fl ame higher, counter-
clockwise for a lower fl ame.

OPERATING

INSTRUCTIONS

1) Read and understand these instructions before

operating this appliance.

2) Check to see that all wiring is correct and

enclosed to prevent possible shock.

3) Check to ensure there are no gas leaks.

4) Make sure the glass in the door frame is properly

positioned. Never operate the appliance with
the glass removed. Never strike the glass.

5) Verify that the venting and cap are unob-

structed.

6) Verify log placement. If the pilot cannot be

seen when lighting the unit - the logs have
been incorrectly positioned.

7) The unit should never be turned off, and on

again without a minimum of a 60 second wait.

the paint and the burning off of any oils remaining
from manufacturing. Smoke detectors in the house
may go off at this time. Open a few windows to
ventilate the room for a couple of hours. The glass
may require cleaning.

DO NOT ATTEMPT TO CLEAN THE GLASS

WHILE IT IS STILL HOT!

Note: When the glass is cold and the appliance

is lit, it may cause condensation and fog
the glass. This condensation is normal
and will disappear in a few minutes as
the glass heats up.

DO NOT BURN THE APPLIANCE
WITHOUT THE GLASS FRONT IN
PLACE.

During the fi rst few fi res, a white fi lm
may develop on the glass front as part
of the curing process. The glass should
be cleaned or the fi lm will bake on and
become very diffi cult to remove. Use a
non-abrasive cleaner and NEVER clean
the glass while it is hot.

I M -

PORTANT: Gas on/off knob cannot be turned
from "PILOT" to "OFF" unless it is partially
depressed.

1) Turn stove OFF using the Burner "ON/OFF"

switch remote or thermostat. Switches are
located at the top right hand corner (rear) of
the stove.

2) Turn gas control knob so indicator points to

"OFF" position and allow 5 minutes for any
gas in the combustion chamber to escape.

3) Turn gas control knob counterclockwise

so indicator points to the "PILOT" position.
Depress the gas control knob fully. Depress
the igniter button several times until the pilot
lights. After approximately one minute, release
the gas control knob. The pilot fl ame should
continue to burn. If the pilot does not remain
lit, repeat operation allowing a longer period
before releasing gas control knob.

4) When the pilot stays lit, turn the gas knob

further counterclockwise to the "ON" position.

5) Use the thermostat or remote control to turn

on the unit.

6) Rotate

the

fl ame height regulator to adjust the

fl ame height higher or lower.

SHUTDOWN

PROCEDURE

1) Use the thermostat or remote control to turn

off the main burner.

2) Turn the main gas control clockwise to the

"OFF" position to turn off the pilot (push knob
in slightly).

3) Turn off all electric power to appliance if service

is to be performed.

FIRST FIRE

The FIRST FIRE in your stove is part of the paint
curing process. To ensure that the paint is prop-
erly cured, it is recommended that you burn your
fi replace for at least four (4) hours the fi rst time
you use it with the fan on. When fi rst operated, the
unit will release an odour caused by the curing of

LIGHTING

PROCEDURE

IMPORTANT

To ignite or reignite the pi-

lot, the door to the fi rebox

must be opened.

NOTE: For all propane units and units

equipped with electric spark boxes, see
"Copy of Lighting Plate Instructions"
section for more details.

Only when the pilot holds, without pressure be-
ing applied to the control knob, should the door
to the fi rebox be closed. The unit must never be
operated with the glass or door open.