Regency Hampton H15 Small Gas Stove - Manual (Page 10)

10
Hampton® H15-1 Direct Vent Freestanding Gas Stove
INSTALLATION
9) Remove 2 screws from unit.
10) Place grommet in rear plate through the
bottom of the opening as shown below.
11) Place the blower close to the base of the unit
and feed the wires through the grommet in
the rear plate.
Grommet Rear Plate
Wires
OPTIONAL FAN
INSTALLATION
Fan Kit Contains:
Qty. Description
1 Fan Assembly c/w green wire attached
1 Thermodisc
1 Fan Speed Control
1 Grommet
1) Remove the rear access panel on the back of
the stove by removing the 2 screws under the
rear panel, then lift rear panel off of 2 bolts at
the top. Take care not to cut wires when lower-
ing the panel.
2) Disconnect the red and grey wires.
Top Control Panel Assembly
Fan Speed
Controller
4) Remove the nylon hole plug from the control
panel.
5) Install the fan speed controller onto the control
panel and secure with nut and washer. Connect
the red and black wires from the wire harness to
speed controller. NOTE: Speed control wires
must be in the down position when control
panel is in place.
6) Push black knob onto speed control.
7) Re-attach control panel with 3 screws, reversing
step 3.
screw screw
Lift Rear Panel off of the 2 top bolts.
bolt
3) Remove the Top Control Panel Assembly
by removing the three screws.
8) Slide Thermodisc into the bracket on the left
side of the rear fi rebox.
Thermodisc Thermodisc
Bracket