Regency Hampton H15 Small Gas Stove - Manual (Page 37)

Hampton® H15-1 Direct Vent Freestanding Gas Stove
37
INSTALLATION
WIRING DIAGRAMS
CAUTION: Label all wires prior
to disconnection when servic-
ing controls. Wiring errors can
cause improper and dangerous
operation.
If any of the original wires as supplied with the
appliance must be replaced, it must be replaced
with CSA type SEW (200
o C) or its equivalent.
This heater does not require a 120V A.C. sup-
ply for operation. In case of a power failure, the
burner switch and the optional remote control/
thermostat will continue to operate. However,
a 120V A.C. power supply is needed for the
fan/blower operation.
Caution: Ensure that the wires do
not touch any hot surfaces and are
away from sharp edges.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from
this plug.
For NATURAL GAS Units and Units NOT Equipped with DC Spark Boxes