Regency Hampton H15 Small Gas Stove - Manual (Page 34)

34
Hampton® H15-1 Direct Vent Freestanding Gas Stove
INSTALLATION
LOG SET INSTALLATION
1) Shut off the gas supply.
2) Lift off Cast Top.
Read the instructions below carefully and refer to the
diagrams. If the logs are broken do not use the unit
until they are replaced. Broken logs can interfere with
the pilot operation.
The log kit contains the following:
a) Rear Log
b) Left Side Front Log
c) Right Side Front Log
d) Center Front Log
e) Embers
f) Platinum Embers 946-669
(supplied with packaged manual)
Left Front Log
3) Remove Cast Front by removing the 2 screws using
a 7/16" wrench. Pull front out and then up as shown
below.
Inside
view
6) Place the rear log on the 2 rear log locating pins
on the rear of the burner with the fl at side to the
back.
5) Carefully remove the logs from the unit and
unwrap them. The logs are fragile, handle with
care - do not force into position.
7) Place the 2 front logs on the front log locating
pins. Ensure the back of both logs rest against
the tabs.
A
A
D
C
C
B
B