Sunnex CS2050D (Dual) - Manual (Page 20)

INSTALLATION AND OPERATING MANUAL
19
6. Operating Instructions
1. After successful assembly of your light, plug the Hospital Grade plug into an appropriate
Hospital Grade outlet. Do not use three-to-two prong adapters that are not grounded.
2. Turn on your light with the rocker switch in the back cover of the lamp head. (If a wall switch
is also in use, be sure to have the rocker switch to off position before turning the wall switch
on.)
CAUTION: IF A WALL DIMMER IS USED WITH THE LIGHT, IT VOIDS
CERTIFICATION LISTING OF THE PRODUCT. NO DIMMERS ARE APPROVED
TO BE USED WITH THIS LIGHT.
Figure 16
Figure 17
RANGES OF MOTION (REFER TO FIGURE 18)
EXTENSION ARM /BALANCE ARM MOVEMENT: The balance arm moves 340 degrees
both horizontally and vertically at its junction with the extension arm.
LAMP HEAD/YOKE & YOKE/BALANCE ARM MOVEMENT: The lamp head rotates 340
degrees at its connection to the yoke. The yoke rotates 560 degrees at its connection to the balance
arm. The two co-act to provide unlimited choices for beam positioning. All axis of rotation have
very little resistance and no force is needed or should be used to rotate the light.
REACH: With the lamp head/balance arm fully extended in the horizontal plane, the reach from
the center of the ceiling “Z” extension arm to beam center is 58” (1.5m).
CEILING EXTENSION ARM MOVEMENT: The ceiling “Z” extension arm rotates 700
degrees. There is a built-in rotation stop which limits rotary movement in either direction.