Sunnex CS2050D (Dual) User Manual
Page 15
INSTALLATION AND OPERATING MANUAL
14
5.2 Installation Instructions
1. Slide transformer housing covers off of transformer brackets and set aside for future
installation.
2. Follow Table 1 and Figures 8, 9 & 10 to determine the location of installation.
3. Fasten the transformer housing to the desired location using four (4) 3/8” or M10 bolts (not
provided). The type of bolt will be dependent on your installation. These bolts may need
to be either lag or machine bolts. Minimum lag bolt length is 2-1/4” or 60mm. Verify that
the transformer housing is level. If not, arm will drift.
4. Position and install transformer housing cover on mounting bracket. Secure with plastic
screws (4) provided.
5. Connect the male connector with the female connector on swivel joint of the balance arm.
Connectors can be installed only one way. Ensure that connectors make a
“CLICK”
sound
for a positive lock.
Inset 1.0 (Figure 8)
6. Line up the holes on arm with the holes on the swivel joint on the balance arm. Use the (3)
pan head screws (#8-32X1/2”) provided to secure the connection.
Inset 2.0 (Figure 8)
7. Fix the round counter weight to other end of the lamp head balance arm. There are two