How to use cm-485, Technical parameters – Schwank ThermoControl Plus Series CM-485 User Manual
Page 3

- 3 -
How to use CM-485
The Module can easily be installed into any ThermoControl Plus controller. The controller will
automatically recognise the presence of the module. The module makes it possible to see the
measured values and to modify any control parameter through the RS485 network.
Any number of devices can be connected to the single twisted wire RS485 network. Every
device has its own address to be able to communicate with the network controller (PC).
Technical Parameters
Bit rate: 600, 1200, 2400, 4800, 9600, 19200 bit/s can be selected
Format: RTU 8 bit, or ASCII 7 bit, parity: none, odd, even
Device address: 1-247 can be set
CONTROLLER
CM-485
HEAT
RS485
PC
Interface
DEVICE2
DEVICE1
DEVICEn
Flashes if there is data
transfer on the RS485
line
Flashes if there is data transfer between
the Module and the controller
Mounting holes
Connection terminals
Flat cable connector to the main board
+ –
Gnd