Schwank ThermoControl Plus Series CM-485 - Manual (Page 18)

- 18 -
In case of P0, P1 application programs:
bit2
: State of Relay 6
In case of P2 application programs:
bit1
: State of Relay 7
In case of P3 application programs:
bit0
: State of Relay 8
*00A4h: State of the heater relays in Zone7:
In case of P0, P1 application programs:
bit1 : State of Relay 7
In case of P2 application programs:
bit0 : State of Relay 8
*00A6h: State of the heater relays in Zone8:
In case of P0, P1 application programs:
bit0
: State of Relay 8
*00A8h: 0 if the maintenance warning counter is switched off (not operating)
*00AAh: Remaining working hours till the next maintenance time
*00ACh: Selected length of the maintenance period (the number of hours)
*00C6h: Work-hour counter content for Relay 1; 4byte length
*00CAh: Work-hour counter content for Relay 2; 4byte length
*00CEh: Work-hour counter content for Relay 3; 4byte length
*00D2h: Work-hour counter content for Relay 4; 4byte length
*00D6h: Work-hour counter content for Relay 5; 4byte length
*00DAh: Work-hour counter content for Relay 6; 4byte length
*00DEh: Work-hour counter content for Relay 7; 4byte length
*00E2h: Work-hour counter content for Relay 8; 4byte length
*01C0h: Serial number of the controller, length: 6 ASCII characters
*01C6h: Name of the controller, max. 10 characters, the end is indicated with “0”
(TC Plus 4)
Common Register Addresses:
The following addresses have the same functions in every controller types:
00F0h-00F5h: Data of the Clock (Real Time Clock)
00F6h-0143h: Data of the time program in a zone
0144h-0174h: Data of the holiday program
*01E0h-01EFh: Data of the display segments (16x8bit)
*01F0h-01FFh: Data of the blinking segments (16x8bit)
*0200h: state of Error(bit 7) and Service (bit 6) LED when 0201h=D2h.
*0201h: D2h, when built-in a second generation LCD.
*0FFDh: Code to identify the type of the controller (without version information): on the
lower 8 bits (Example: TCP-1: 0031h or 0035h).
*0FFEh: ID number of the CM-485 module (RevB: 0012h).
Available only in
controllers produced
after 01.05.2008.