Salsbury Industries 40000 Series Heavy Duty Plastic Lockers - Manual

Heavy Duty Plastic Lockers – 40000 Series
Locker Installation Instructions
Thank you for selecting 40000 Series Heavy Duty Plastic Lockers. We are confident that the quality and construction of the lockers will prove to be a
good investment. These instructions are intended to assist you in the assembly, placement, and anchoring of your lockers. Individual job conditions
will dictate whether the lockers must be anchored to the wall, the floor, or both.
Separate parts from packaging and make sure all parts are accounted for before discarding any packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
Lockers should be installed in a climate-controlled environment and shielded from direct sunlight. All lockers
must be either secured against a wall or installed back-to-back (for island configuration).
Make sure all floors and walls are clean and smooth. Remove loose impediments, such as protruding nails, and
other debris which could affect installation. The lockers must be square and level and floor supported or they will
not operate properly. A locker that is square may not be level, so be sure to check both.
Review your locker layout drawings and verify the number of lockers and components before beginning
installation.
Carefully lift lockers at the base when moving and positioning. Do not drag the lockers.
LOCKER BASES MUST BE SQUARE AND LEVEL, AND ANCHORED TO THE FLOOR BEFORE THE LOCKERS ARE
INSTALLED. THE LOCKERS WILL NOT OPERATE PROPERLY IF THE BASE IS NOT SQUARE AND LEVEL AND
NOT FLOOR-SUPPORTED. A LOCKER BASE THAT IS SQUARE MAY NOT BE LEVEL, SO BE SURE TO CHECK
BOTH.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE AND WILL VOID THE LOCKER WARRANTY.
Tools required: Tape measure - - - 9/32” drill bit - - - hammer drill for drilling into concrete - - - 6’ level and shims - - - power drill - - - Phillips driver
bit - - - clamps - - - 3/16” masonry drill bit (6” long minimum) - - - circular saw - - - right-angle power drill - - - chalk and string.
The following tips may be helpful: A string line along the top and bottom of the lockers may be used to help in alignment. If shims are required
after locker installation is complete, remove obstructive screws, apply the shims, then replace the screws. Avoid twisting the locker frames when
applying shims.
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering @ lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 05, 1/13/2010) Page 1 of 6