Salsbury Industries 76000 Series Vented Lockers Box Style - Manual

Vented Lockers – 76000 Series
Box Style Installation Instructions
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com [email protected]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. Page 1 of 5 3/27/14
SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Thank you for selecting Salsbury’s vented box style lockers. These instructions are intended to assist you in assembling the lockers. Assembly of the various locker components will be
with #10 - 24 x 3/8” long slot less screws and #10 nuts (provided). Loosely fasten a screw and a nut into every set of mating holes with the screw heads positioned on the outside of the
locker or on the exposed surface.
One Wide Locker Assembly
Step 1: Attach the top shelf and bottom shelf to the back panel.
Step 2: Turn the back panel on its back with the shelves pointing upward. Attach the
first side panel, the left rear leg, and five compartment dividers to the assembly from
Step 1.
Step 3: Attach the second side panel and the right rear leg to the assembly of Step 2.
The locker chassis is now complete.
Step 4: Attach the pre-assembled door frame onto the assembly of Step 3.
Step 5: Tighten all fasteners checking for squareness of the locker while tightening.
Attach optional sloping hood, end bases or front base (see pages 4 and 5).
Step 6: Place the locker in the installed location and anchor to the floor, wall, or to
both. Individual job conditions will dictate the type of fastening anchors to use (not
provided).
Step 7: Fasten all lockers in a row together by installing fasteners provided through
the side panels. Installation is now complete.