Salsbury Industries 19000 Series Cell Phone Lockers Surface Mounted - Manual

SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Phone: 1-800-624- 5269 Int’l Phone: 323-846-6700
Fax: 1-800-624- 5299 Int’l Fax: 323-846-6800
www.lockers.com www.mailboxes.com engineering @ mailboxes.com [email protected]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. (Rev. 12, 1/21/2014) Page 1 of 10
Cell Phone Lockers - 19000 Series
Surface Mounted Installation Instructions
Installation of the Surface Mounted Enclosure
Remove the locker unit from the enclosure. Drill mounting holes in
the enclosure to fasten it to the mounting surface. It is important to
use at least four (4) fasteners (not provided) and place one each at
the four (4) corners of the mounting surface (either on the rear panel
or the bottom panel). Choose appropriate hardware for the particular
conditions of the installation.
Installing the Cell Phone Locker into the Enclosure
Install the locker unit into the enclosure by sliding it into the enclosure
until its front peripheral flange is flush against the front of the
enclosure. Open the four corner compartments of the cell phone
locker. Install #8 x 1-1/4 in. long screws (provided) through the top
and bottom of the locker unit into the enclosure. Close the
compartment doors.