Salsbury Industries 77000 Series Locker Options - Manual

SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering @ lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2013 Salsbury Industries. All rights reserved. (Rev. 06, 2/19/2013) Page 1 of 7
Locker Options – 77000 Series
Installation Instructions
Thank you for selecting Salsbury’s options for standard lockers. We are confident that the quality and construction of the optional items will prove to
be a good investment. These instructions are intended to assist you in assembling various optional items onto the lockers. The items are separate
options and may or may not be included with your order.
Name Plates
The name plates are installed with two (2) #4 slot less screws and
nuts.
Sloping Hoods
The sloping hoods are assembled with ten (10) #10 x 3/8” slot less
screws and nuts. The side plates should be installed over the
flanges of the sloping panel.
The four tapped holes in the bottom of the sloping hood assembly
align with holes preexisting in the top panel of the locker assembly.
Use four (4) slotted or Phillips head #10 screws installed from the
inside of the locker to attach the sloping hood.
Front Bases and End Bases
The front bases are simply snapped into position between the two
legs in the front of the locker unit. No fasteners are required due to
the dimples on the front base flanges.
The end bases are installed and fastened with two (2) screws and
nuts such that the end base front edge is inserted inside the locker
front leg with the end base rear flanges wrapped around the outside
of the locker rear leg.