Retsch RM 200 - Manual (Page 23)

11/6/2012 23  Retsch GmbH 0002
Stopping the milling process
• Press the stop button R . Fig.14
Pressing the button once interrupts the milling
operation in order that, for example, the material to
be milled can be assessed. The remaining milling
time is still visible in the display U . By repressing
the start button the mill continues to run until the
milling time has completely elapsed.
• Pressing the stop button twice stops the milling
operation and the machine is then in the stand-by
mode.
• By pressing the start button the display is
reactivated and the milling time is reset to the last
start value.
During the milling operation the time can be
adjusted by pressing the + or – button.
The milling operation is automatically ended after
the milling time has elapsed. The display is reset to
the last started value.
Replacing the machine fuses
Fig.15
The following visible type fuses are required for the
RM200:
2 MT 3.15 A for 230V machine
2 MT 6.30 A for 100V to 120V machine
Replacing the fuses Fig.15
• Unplug mains plug from the machine socket A
• Unlock and remove the fuse compartment B by
pressing the locking device upwards.
• Replace the fuses
• Insert fuse holder B
B
A