Retsch PM GrindControl - Manual (Page 11)

The First Start
11
Pos : 6.2 /00020 BD A Software/20005 PM GC Kapitelsamml ung/Ü berschriften/1. Ü berschriften/1 D er erste Start @ 0\mod_1208854281759_9.doc @ 324 @ @ 1 Der
4 The First Start
Pos : 6.3 /00020 BD A Software/20005 PM GC Kapitelsamml ung/Ü berschriften/1.1 Ü bersc hriften/11 Vollständiger Programm-Ablauf bis zur ersten Messung @ 0\mod_1218549278088_9.doc @ 2270 @ @ 1
4.1 Complete Program Sequence up to First Measurement
Pos : 6.4 /00020 BD A Software/20005 PM GC Kapitelsamml ung/0005 D er erste Start/Modul Der erste Start @ 0\mod_1209020476978_9.doc @ 600 @ @ 1
The following sequence presents only the steps necessary for the first activation
and the test to see if the wireless grinding jar cover is functioning perfectly.
Read all chapters in this operating manual!
This description of the first activation of a wireless grinding jar cover does not
replace the need to read the operating instructions. Read the other chapters in this
manual too.
Please also read and observe the operating instructions for your planetary ball mill!
1.
First, charge the three storage batteries completely using the charging
adapter in the accompanying charger. Read the chapter on OPERATING
INSTRUCTIONS POWERLINE 5 LCD beforehand
2. Follow the instructions in the Software Installation chapter and install the
USB driver for the ZigBee USB – wireless unit, the USB driver for the TG-
ETRXn USB port and the PM GrindControl software.
3. Start the PM GrindControl software.
Do not pull the Telegesis (ZigBee) USB Stick out of the USB port as long as
the PM GrindControl software is active.
If the PM GrindControl software does not find the USB wireless unit (Telegesis),
you must connect the USB-stick manually once again. This requires the following
steps:
• Confirm the warning with OK.
(the PM GrindControl software starts)
• In program, PM GrindControl prodram select
Settings > Options > .
• Click on the Connect Again button
4. Insert the 3 fully charged batteries 1 into the wireless grinding jar.
The status indicator lamp starts to flash red and then glows a steady red.
Execute the following command in the PM GrindControl software::
5. Menu File  Measurement task, new
6. Assign a new name to the first measurement task and save the file to a local
drive (e.g. C:\).
The measurement tasks must be saved to a local drive.
The Configure Measurement Systems program window is displayed.
7. Go to the MAC address filed and enter your grinding jar’s MAC address
number sequence.