MacDon D65 - Manual (Page 17)

REAR AXLES AND WHEELS
169784 15 Revision A
STEP 6. INSTALL REAR FIXED
AXLE
a. Position a 2x4 wooden block or equivalent
between the right-hand leg and draper to allow
installation of the support assembly.
b. Check that spacer (A) is installed in axle.
c. Position fixed axle assembly (B) in leg and align
mounting hole in axle with aft hole (C) in leg.
d. Remove bolt (D), washers, and nut from pivot
casting (E).
e. Position pivot casting assembly (E) on leg.
f. Install two 21/32 in. I.D. flat washers (F) under bolt
(D) head and install through leg and assembly (E).
g. Install four 21/32 in. I.D. flat washers (F) and
smooth faced locknut (G) on threaded end of bolt
(D). Do not tighten.
B
C
A
D
E
D
F
G
F
E
D