Omnitron Systems Technology FlexSwitch 6500 FK AC - Manual (Page 6)

is disabled when the UTP port is configured for manual negotiation.
UTP 10/100Mbps “10/100” DIP-Switch (Port 1 or Port 2)
When the UTP “AN/MAN” DIP-Switch (described above) is in the manual
“MAN” position, the “10/100” DIP-Switch determines the speed of operation
for the designated UTP port. Setting the “10/100” DIP-Switch to “100” position
(factory default) forces the UTP port to operate at 100Mbps. Setting this DIP-
Switch to “10” position forces the UTP port to operate at 10Mbps. Adjust the
“10/100” DIP-Switch to match the speed of the connecting UTP device.
UTP Full/Half-Duplex “HD/FD” DIP-Switch (Port 1 or Port 2)
When the UTP “AN/MAN” DIP-Switch (described above) is in the manual
“MAN” position, the “HD/FD” DIP-Switch determines the duplex operation
mode for the UTP port. Setting the “HD/FD” DIP-Switch to UTP Full-Duplex
“FD” (factory default) position forces the UTP port to operate in Full-Duplex.
Setting this DIP-Switch to “HD” forces the UTP port to operate in Half-
Duplex. Adjust the UTP Half/Full-Duplex DIP-Switch to match duplex mode
the connecting UTP device.
When the UTP “AN/MAN” DIP-Switch is in the Auto-Negotiate “AN” position
and the UTP Full/Half Duplex DIP-Switch is in the Full-Duplex “FD” position,
the UTP port Auto-Negotiates to Full or Half-Duplex. When in the Half-
Duplex “HDX” position, the UTP port functions only in Half-Duplex.
Page 6