New Era NE-1600 Multi-Phaser Programmable Syringe User Manual
Page 4
New Era Pump Systems Inc.
WWW.SYRINGEPUMP.COM
Model NE-1600/NE-1800 Multi-Phaser™
Publication #1200-02
iii
8/1/14
6.1.1
Default Volume Units .................................................................................................................................... 12
6.1.2
Changing Volume Units ................................................................................................................................. 12
6.2
Start/Stop Triggers .............................................................................................................................. 13
6.3
Operating the Pump ............................................................................................................................ 13
6.4
Purging .................................................................................................................................................. 13
6.5
Changing the Pumping Rate and Direction While Pumping ........................................................... 13
6.6
Volume Dispensed ................................................................................................................................ 13
6.7
Resuming When Paused ...................................................................................................................... 14
6.8
Pump Stalled ........................................................................................................................................ 14
7.
Setup Configuration...................................................................................................................... 14
7.1
Power Failure Mode ............................................................................................................................ 15
7.2
Low Noise Mode ................................................................................................................................... 15
7.3
Audible Alarm Enable ......................................................................................................................... 15
7.4
TTL I/O Operational Trigger Default Configuration ...................................................................... 15
7.5
TTL I/O Directional Control Input Configuration ........................................................................... 16
7.6
Pump Motor Operating TTL Output Configuration ....................................................................... 16
7.7
Keypad Lockout ................................................................................................................................... 16
7.8
Keypad Beep Enable ............................................................................................................................ 16
7.9
RS-232 Pump Network Configuration ............................................................................................... 17
8.
Pumping Program ......................................................................................................................... 17
8.1
How to Enter Pumping Programs ...................................................................................................... 18
8.1.1
Pumping Program Phase Number .................................................................................................................. 18
8.2
Pumping Program Edit Functions ..................................................................................................... 19
8.3
Program Function Descriptions .......................................................................................................... 19
8.3.1
‘rAtE’: Rate Function ..................................................................................................................................... 19
8.3.2
‘FILL’: Fill Function ...................................................................................................................................... 19
8.3.3
‘Incr’: Increment Rate Function .................................................................................................................... 20
8.3.4
‘DEcr’: Decrement Rate Function................................................................................................................. 20
8.3.5
‘StoP’: Stop Pumping Operation and End the Program ................................................................................ 20
8.3.6
‘JP:nn’: Jump to Phase .................................................................................................................................. 20
8.3.7
'Pr:In': Sub-Program Selection Input ............................................................................................................. 20
8.3.8
'Pr:nn': Sub-Program Start Label .................................................................................................................... 21
8.3.9
‘LP:ST’: Define Starting Phase of Loop ....................................................................................................... 21
8.3.10
‘LP:EN’: Define Continuous Loop End ........................................................................................................ 21
8.3.11
‘LP:nn’: Define Loop End and Loop Repetitions ......................................................................................... 21
8.3.12
'PS:nn': Pause Pumping ................................................................................................................................. 21
8.3.13
'IF:nn': Jump to Phase If External Trigger .................................................................................................... 22
8.3.14
'Et:nn': Setup Event Trigger Jump Phase ...................................................................................................... 22
8.3.15
'ES:nn': Setup Event Square Wave Trigger Jump Phase ................................................................................ 22
8.3.16
‘Et:rS’: Event Reset ....................................................................................................................................... 22
8.3.17
‘CLr.d’: Clear Total Volume Dispensed ........................................................................................................ 22
8.3.18
‘tr:aa’: Override Operational Trigger Configuration ...................................................................................... 23
8.3.19
‘Out.n’: Set TTL Output Pin ......................................................................................................................... 23
8.3.20
‘bEEP’: Beep................................................................................................................................................. 23
8.4
Pumping Program Examples .............................................................................................................. 23