New Era NE-500 Multi-Phaser Programmable OEM Syringe - Manual (Page 46)

New Era Pump Systems Inc.
www.SyringePump.com
Model NE-500/NE-501 Multi-Phaser™
Publication #1200-02 41 09/18/14
10. Appendix
10.1 RS-232 Command Summary
=>
DIA [ < float > ]
Syringe inside diameter
PHN [ < phase data > ] Program Phase number
FUN [ < phase function > ] Program Phase function
< phase function > =>
RAT Pumping rate.
FIL Fill syringe to volume dispensed.
INC Increment rate.
DEC Decrement rate.
STP Stop pump.
PAS Pauses pumping for ‘nn’ seconds, if 0, wait for start trigger.
PAS [n.n] Pauses pumping for 'n.n' seconds.
JMP Jump to Program Phase.
PRI Sub-Program Selection Input from expansion connector
PRL Sub-Program Start Label definition.
LPS Loop starting Phase.
LOP Loop to previous loop start ‘nn’ times.
LPE Loop end Phase.
IF If Program input low, jump to Program Phase.
EVN Set event trigger.
EVS Set event square wave trigger.
EPL Pause program, wait for low edge or level on expansion pin
EPE Pause program, wait for falling edge on expansion pin
EVE Re-direct event trigger to expansion pin
EVR Event trigger reset.
CLD Clear total dispense volume.
OUT { 0 | 1 } Set programmable output pin.
OE0 Set expansion pin low
OE1 Set expansion pin high
TRG Override Operational Trigger default setting
BEP Sound short beep.
RAT {C | I ] [ [ UM | MM | UH | MH ]] Pumping rate
VOL [ | ]
Volume to be Dispensed, or set Volume units
DIR [ INF | WDR | REV | STK ] Pumping direction
RUN [ ] Starts the Pumping Program
[E [] ] Pumping Program event trigger
PUR Start purge
STP Stop/pauses the Pumping Program
DIS Query volume dispensed
CLD { INF | WDR } Clear volume dispensed
SAF [ [ [ ] ] ] Safe communications mode
LN [ 0 | 1] Low motor noise mode
AL [ 0 | 1] Alarm buzzer mode
PF [ 0 | 1] Power failure auto-restart mode
TRG [ FT | FH | F2 | LE | ST | T2 | SP | P2 | RL | RH | SL | SH | OF ] Operational trigger default mode
DIN [ 0 | 1] Directional input control mode
ROM [0 | 1] Pump Motor Operating TTL output mode
LOC [ P ] [ 0 | 1]] Keypad lockout mode or Program Entry Mode lockout
BP [ 0 | 1] Key and Notification beep mode
OUT [ E | 5] { 0 | 1 } Set TTL output level
IN { E | 2 | 3 | 4 | 6 } Query TTL input level
BUZ [ 0 | { 1 [ < n > ] } ] Buzzer control
VER Query firmware version
System Commands: Valid regardless of current network address
*ADR [ [] [ B ] ] Network address and baud rate