New Era NE-500 Multi-Phaser Programmable OEM Syringe - Manual (Page 36)

New Era Pump Systems Inc.
www.SyringePump.com
Model NE-500/NE-501 Multi-Phaser™
Publication #1200-02 31 09/18/14
Set:
Currently selected Phase is set to . Previous Phase is stored in non-volatile memory and
the requested Phase is recalled from the non-volatile memory. Set is only valid if the Pumping
Program is not operating.
Query response:
Currently selected Phase
PUMPING PROGRAM FUNCTION
FUN [ ]
Set/query the Pumping Program Phase’s function.
This command is relevant to the currently selected Phase. Set is only valid if the Pumping Program is
not operating
For a more detailed description of Program commands, see sec. 7.3, Program Function Descriptions.
=>
Rate Data Functions
When a Phase’s function is set to a “Rate Data Function”, use the ‘RAT’, ‘VOL’, and ‘DIR’
commands to setup the pumping parameters for the current phase.
RAT Pumping rate.
FIL Fill syringe to dispensed volume
INC Increment rate.
DEC Decrement rate.
Non-Rate Control Functions
STP Stop pump.
PAS Pauses pumping for ‘nn’ seconds, or until trigger if 0.
PAS Pauses pumping for 'n.n' seconds.
LOP Loop to previous loop start ‘nn’ times.
LPS Loop starting Phase.
LPE Loop end Phase.
JMP Jump to Program Phase.
TRG Override Operational Trigger Default Mode, set to
Conditional Functions
IF If Program input TTL pin low, jump to Phase.
EVN Set event trigger trap.
EVS Set event square wave trigger trap.
EPL Pause and wait for expansion pin event edge or level.
EPE Pause and wait for expansion pin event edge.
EVE Re-direct event trigger trap to expansion pin.
EVR Event trigger trap reset.
CLD Clear total dispense volume.
TTL Logic and Other Functions
OUT Set programmable output pin.
OE0 Set expansion pin to 0 (low level).
OE1 Set expansion pin to 1 (high level).
BEP Sound short beep.
PUMPING RATE
RAT [ C | I ] [ [ ] ]
Set/query pumping rate.
=> UM = µL/min
MM = mL/min
UH = µL/hr
MH = mL/hr