Multiquip MQ600TD80 - Manual (Page 25)

mq600Td80 TRaSH pUmp• opeRaTion and paRTS manUal — Rev. #11 (10/10/11) — page 25
Maintenance
geneRal inSpeCTion
The following maintenance guidelines are intended to
assist the operator in preventative maintenance. For a more
detailed maintenance schedule refer to the Deutz Engine
Manual supplied with the pump.
At least
daily or prior to each use, the MQ600TD80 trash
pump cover should be removed, and the pump should be
cleaned and inspected for deficien cies. Check for loose,
missing or damaged nuts, bolts or other fasteners. Also
check for fuel or oil leaks, and remove any debris stuck in
the impeller or volute.
CHeCK oil level
Check the engine crankcase oil level prior to each use, or
when the fuel tank is filled. Make sure the pump is level. The
oil level must be between the two notches on the dipstick
as shown in Figure 11.
Figure 11. Engine Oil Dipstick
CHanging engine oil
Change engine oil after first 20 hours of opera tion. Drain
and refill engine crankcase with the correct type and
amount oil (see Table 5) after 250 hours of operation hours
or once a week thereafter.
When draining engine crankcase oil, place oil into a suitable
container while engine is still warm. Replace the drain plug
tightly. Add oil through the filler hole.
CHanging oil FilTeR
Change the Deutz engine oil filter (Figure 12) after 250
hours of operation.
Figure 12. Engine Oil Filter
FUel FilTeR SySTem
The Deutz engine fuel system incorporates four different
types of fuel filters, in-line, easy change, IMSA, and a fuel
water separator.
in-line FUel FilTeR
Replace the in-line fuel filter (Figure 13) every 500 hours. If
the purity of the fuel being used is of lesser quality replace
the in-line fuel filter more often as needed.
Figure 13. In-Line Fuel Filter
OIL
FILTER
NOTICE
When reinstalling fuel filters, please note the arrows
indicating the direction of fuel flow.