Multiquip MQ600TD80 - Manual (Page 22)

page 22 —mq600Td80 TRaSH pUmp • opeRaTion and paRTS manUal — Rev. #11 (10/10/11)
startup
engine oil
1. Make sure pump/engine is on level ground.
2. Pull the engine oil dipstick from its holder.
3. Verify that oil level (Figure 6) is maintained between
the two notches on the dipstick.
Figure 6. Engine Oil Dipstick
4. If engine oil is low, fill engine crankcase with lubricating
oil through filler hole (Figure 7), but do not overfill.
Figure 7. Engine Oil Filler Hole
CaUTion
do noT attempt to start the engine unless the pump
has previously been primed with water. Severe damage
to the pump's mechanical seal will occur if pump has not
been primed.
5. The oil listed in Table 5 is recommended to ensure
better engine performance. Use class CD or higher
grade motor oil.
FUel
1. Determine if engine fuel is low by reading fuel indicator
gauge on top fuel cap. Fill with recommended type
diesel fuel.
do noT fill the tank beyond capacity.
2. Handle fuel in a safety container. If the container does
not have a spout use a funnel.
3. Pay attention to the fuel tank capacity when replenishing
fuel. Refer to the fuel tank capacity listed in Engine
Specifications Table.
4. Tighten fuel tank cap securely after filling.
dangeR
NEVER fill the fuel tank while the engine
is running or in the dark. Fuel spillage on
a hot engine can cause a fire or explosion.
If fuel spillage occurs, wipe up the spilled
fuel completely to prevent fire hazards.
dangeR
DO NOT smoke while refueling. Motor
fuels are highly flammable and can be
dangerous if mishandled.