Multiquip MVH206D - Manual (Page 24)

PAGE 24 — MVH206D PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #1 (10/25/11)
BLEEDER
PLUG
HYDRAULIC
CYLINDER
Figure 28. Bleeder Plug
ADDING HYDRAULIC OIL
1. Remove the breather cap and oil plug (Figure 26) from
the hydraulic oil tank using a 24mm hex socket.
2. Using a funnel, add Shell Tellus Oil #46 or equivalent
to the hydraulic oil tank through the oil filler port (Figure
27). Oil tank capacity is 50.7 fl. oz (1500 cc).
MAINTENANCE
BREATHER
CAP
OIL
TANK
HYDRAULIC
OIL PLUG
(24 MM WRENCH)
Figure 26. Hydraulic Oil Tank
SH
ELL TEL
LU
S
0IL
#46
HYDRAULIC
OIL TANK
FRONT VIEW
OIL LEVEL
REAR VIEW
FILL TO
THIS LEVEL
Figure 27. Hydraulic Oil Maintenance
CAUTION — Hydraulic Oil Overfill
Make sure hydraulic oil is at a normal safe operating
level. DO NOT overfill. Overfilling (excessive oil) will
cause excess oil to blow out of breather plug.
HYDRAULIC
HOSE
HYDRAULIC OIL
CYLINDER
Figure 25. Hydraulic Oil Cylinder
3. Loosen bleeder plug located at top of hydraulic cylinder
on side of vibrator (Figure 28). Air remaining in the
circuit will be forced out of the bleeder plug. Once all
air has been purged from the hydraulic system, tighten
bleeder plug securely.
4. Reinsert oil plug into hydraulic oil tank and tighten
securely. Reinstall breather cap.