MTS Reporter Add-In User Manual
Page 28
a) Double-click
b) Delete the Test Run Review Graph, Test Run Results, or any other objects in the report template.
When you are finished, only the header information should be remaining.
c) Delete the Sheet2 and Sheet3 tabs at the bottom of the spreadsheet. These tabs will not be used.
d) Click the MTS Test Suite Report tab, which is located above the Excel ribbon.
e) Select a row under the header information in the spreadsheet.
f) Click Raw Data, which is located in the Excel ribbon.
g) On the left side of the Data Acquisition field, click the … button.
h) Select a data acquisition activity, such as DAQ: Crosshead, …
i) Click OK.
j) In the Signal List, click the green + icon. The Select Signals window appears.
k) Move a few signals to the list of selected variables on the right side of the window, such as _Load
and _Time.
l) Click OK to close the Select Signals window.
m) Click OK to close the Insert Raw Data window. At this point, your template should look like the
following:
n) In Excel, click File > Save As.
o) Rename the report template to "Default Report with Raw Data."
p) Close Excel.
3. Add the modified report template to the test.
a) On the Report Templates tab, click the green plus sign icon.
Note:
If you are using TWE, click the icon located in the Test Run area—not the Test area.
b) Select the Default Report with Raw Data.xltx template and click Open. The report template now
appears on the Report Templates tab as
Now that you have created the appended raw data report template and added it to your test, you can follow
the steps described in
Appending Data to a Single Report
(p. 27) to incorporate this report template into
your test procedure. When you successfully run the test, you will receive a report containing raw data
appended from each test run into a single Excel file.
28 | MTS TestSuite
Working With Test Reports