MTS Advantage Screw Action Grip - Manual (Page 41)

MTS Advantage™ Screw Action Grips Maintenance 41
Maintenance
This section provides information on the MTS Advantage Screw Action
Grip lubrication, general maintenance, and replacement parts.
General Maintenance
Lubrication
After approximately 500 uses or weekly, whichever comes first, remove the
grips and apply a lubricant to the piston screw’s threaded barrels and to the
surface of the puck face.
Cleaning Periodically check the face surfaces for debris buildup. Clean them if
necessary. Face surfaces will wear out and will need to eventually be
replaced. Use only MTS replacement parts.
Do not use oil or alcohol based solvents or abrasive material to clean
rubber face surfaces.
Using oil or alcohol based solvents or abrasive material such as Scotch-Brite
on rubber face surfaces can cause product damage.
Rubber face surfaces should be cleaned using a clean soft cloth dampened
with a water based solvent. Do not use oil or alcohol based solvents or
abrasive material such as Scotch-Brite™.
Metal face surfaces can be cleaned using an oil or alcohol-based solvent and
a soft wire brush. Be sure to brush parallel with the grooves.
CAUTION