MK Diamond MK-101 JCS Rental - Manual (Page 34)

MK-101 Home Depot Rental Revision 04/05, Effective Date April 21, 2005 Page 34
MAINTENANCE AND TROUBLESHOOTING
4. V-Belt Inspection, Adjustment and Replacement:
The MK-101 is designed with a power transmission V-belt. In order to ensure the MK-101 operates at peak
efficiency, the V-belt should be inspected monthly, and changed if the V-belt shows damage and/or excessive
wear.
NOTE: 1. When a new belt is installed, it should be inspected and re-tensioned after the first forty-eight (48) hours
of operation.
* A GFCI wall socket is the preferred protective device.
Inspect
V-belt
Off
Position
ON/OFF
Switch
(D)
Remove the Cutting Head (See
Adjusting the Cutting Head
(I)
Loosen the Motor Adjustment
Strap
(H)
Loosen the motor mounting bolts, if
re-tensioning only go
to step N
(G)
Check the belt for proper tension
if tension is correct, go to step R
(proper tension 1/8-inch)
(F)
Inspect the V-belt for cracks,
Fraying, separation and wear. Go to
step H if replacement required
(E)
Remove the Belt Guard
(A)
Ensure the ON/OFF Switch
is in the OFF position
(B)
Unplug the GFCI from the Power
source*
(C)
Remove the Diamond Blade
Diamond
Blade
Retaining
Bolts
Unplug
Cutting
Head
Three
Bolts
Rotate Counter-
clockwise to
loosen
7/16-inch
Wrench
Check Tension
1/2-way
between pulleys
Rotate Counter-
clockwise to
loosen
9/16-inch
Wrench
Adjustment
Strap Bolt
Rotate Counter-
clockwise to
loosen
1/2-inch
Wrench