MK Diamond MK-101 JCS Rental - Manual (Page 27)

MK-101 Home Depot Rental Revision 04/05, Effective Date April 21, 2005 Page 27
SETUP, ADJUSTMENT and OPERATION
7. Cleanup:
NOTES: 1. If an external water source was used, steps A through C may be skipped.
2. Dispose of waste water in accordance with applicable Federal, State and Local laws.
Ensure the saw is disconnected before completing the remainder of the cleanup process.
* A GFCI wall socket is the preferred protective device.
Cooling Flow
Points
Off
Position
ON/OFF
Switch
(D)
Ensure the ON/OFF Switch
is in the OFF position
(F)
Unplug MK-101 from the GFCI
(E)
Unplug the GFCI from the Power
source
(B)
Place the Water Pump
In an external container
(A)
Clean the Water Pump
suction of all debris
(C)
Run the MK-101 until clear
water is seen at the blade
cooling ports (Approx. 1 minute)
(H)
Remove the Water Basin
from the MK-101
(I)
Clean the Water Basin
(G)
Clean the MK-101 with
soap and clean water
Clean Water
Basin
Soap and
Fresh Water
Pump
Suction
Water Pump
In container
External
Container
Unplug
GFCI
Slide Water Basin out
of the front of the Saw