MK Diamond MK-101 Tracker - Manual (Page 32)

MK-101 TRACKER Revision 06/05, Effective Date June 07, 2005 Page 32
MAINTENANCE AND TROUBLESHOOTING
Retaining
Bolts
Rotate Counter-
clockwise to
loosen
1/2-inch
Wrench
Check Tension
1/2-way
between pulleys
Three
Bolts
7/16-inch
Wrench
(K)
Remove the V-belt
(M)
Verify the V-belt is seated in the
grooves of both pulleys
(J)
Push the motor toward the
front of the Cutting Head to
loosen the V-belt
(L)
Install the new V-belt
(N)
Tighten the Motor Adjustment
Strap to remove slack
(O)
Check V-belt tension
(proper tension 1/8-inch)
(P)
Repeat steps N and O until
proper V-belt tension
is achieved
(Q)
Tighten the motor
mounting bolts
(R)
Install the Belt Guard
Continue Adjustment
Until Correct
Direction of push
Old V-belt New V-belt
Belt Seated
Pulley
Rotate clockwise
to tighten
9/16-inch
Wrench
Rotate clockwise
to tighten
Rotate clockwise
to tighten