MK Diamond MK-101 Tracker - Manual (Page 24)

MK-101 TRACKER Revision 06/05, Effective Date June 07, 2005 Page 24
SETUP, ADJUSTMENT and OPERATION
7. Cleanup:
NOTES: 1. If an external water source was used, steps A through C may be skipped.
2. Dispose of wastewater in accordance with applicable Federal, State and Local laws.
Ensure the saw is disconnected before completing the remainder of the cleanup process.
* A GFCI wall socket is the preferred protective device.
Cooling Flow
Points
Off
Position
ON/OFF
Switch
(D)
Ensure the ON/OFF Switch
is in the OFF position
(F)
Unplug MK-101 TRACKER from
the GFCI
(E)
Unplug the GFCI from the
Power source
(B)
Place the Water Pump
In an external container
(A)
Clean the Water Pump
suction of all debris
(C)
Run the MK-101 TRACKER until
clear
water is seen at the blade
(H)
Remove the Water Basin
from the MK-101 TRACKER
(I)
Clean the Water Basin
(G)
Clean the MK-101 TRACKER
with
soap and clean water
Clean Water
Basin
Pump
Suction
Water Pump
In container
External
Container
Unplug
GFCI
Slide Water Basin out
of the front of the Saw
Soap and
Fresh Water