MK Diamond MK-101 Tracker - Manual (Page 11)

MK-101 TRACKER Revision 06/05, Effective Date June 07, 2005 Page 11
UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
UNPACKING:
Your MK-101 TRACKER has been shipped from the factory thoroughly inspected. Only minimal assembly is
required.
Use proper lifting techniques when lifting the MK-101 TRACKER.
CONTENTS:
In your container, you will find one (1) MK-101 TRACKER frame and water basin, one (1) MK-101 TRACKER
Cutting, one (1) (1) MK-101 TRACKER removable cutting table, one (1) 10-inch wet cutting continuous rim
diamond blade, one (1) adjustable cutting guide, one (1) electric water pump, one (1) pump discharge fitting,
one (1) cooling transfer tube, one (1) flow adjusting clamp, one (1) drain plug, one (1) blade wrench one (1)
splash guard, one (1) owners manual, one (1) pump manual and one (1) warranty card.
MK-101 TRACKER
Frame
and Water Basin
MK-101 TRACKER
Cutting Head
Removable Cutting
Table
Diamond Blade Adjustable
Cutting Guide
Electric
Water Pump
Pump
Discharge Fitting
Cooling
Transfer Tube
Flow
Adjusting Clamp
Drain Plug
Wrench Splash
Guard
Owners
Manual
Pump
Manual
Warranty
Card
TRANSPORT:
1. The MK-101 TRACKER weighs approximately one hundred and seven (107) pounds.
2. Never transport the MK-101 TRACKER with water in the Water Basin.
The MK-101 TRACKER is designed with a rigid frame removable Cutting Head and Cutting Table. Two
people are required to transport the MK-101 TRACKER with the Cutting Head installed. Remove the Cutting
Table before transport. Remove the Cutting Head if one person is transporting the saw (see Cutting Head
Installation and Removal in the following section).
Cutting Head
Lift Point
Lift Point
Lift the saw using the
lift points shown.
Cutting Table