MK Diamond MK-370 EXP - Manual (Page 41)

41
“Rodding" cooling channels is performed by inserting a small wire rod through the
cooling inlet on top of the Blade Guard and directing the rod out through each of the
cooling flow tubes located on the underside of the Blade Guard. The cooling channels
should be “rodded" until all ports are free of foreign debris.
(K)
Rod Cooling Channels and
recheck flow
BLADE STOPS TURNING
(A)
Verify all plugs are fully
installed
(C)
Check power source voltage
is 120v – if not 120v, move to
another circuit
(B)
Check to see if the wall outlet
Ground Fault Circuit Interrupter
(GFCI) is tripped. Verify circuit
breaker not tripped. If tripped,
reset once
MK-370EXP SAW TROUBLESHOOTING
NOTE: