Mk-370exp saw troubleshooting – MK Diamond MK-370 EXP User Manual

Page 34

1/2-inch Wrench

(B)

Inspect Tile Saw

for damage

If alignment problems are the result of a warped blade, a bent frame or bent support arm,

or, if alignment is off by more than 1/8-inch, contact the MK Diamond Service Center -

(800) 474-5594

Combination Square

12-inch or Greater

Flat Head Screwdriver

1/4-inch Wrench

(A)

Remove Tile Saw

from Power Source

(C)

Inspect Diamond Blade

for damage

The Movable Cutting Table of the MK-370EXP Saw is pre-aligned in the factory. It may become

misaligned with the Cutting Head of the Tile Saw over time. Should misalignment occur, perform the

following steps to realign it.

TOOLS NEEDED:

PREPARATION

ALIGNMENT

MK-370EXP SAW TROUBLESHOOTING

NOTE: