MK Diamond MK-370 EXP - Manual (Page 22)

22
SETUP FOR OPERATION
1. Before powering or starting, check for damage that could prevent this
equipment from proper operation or performing it’s intended function. Check
for binding and alignment of moving parts. Check for damaged, broken, or
missing parts.
2. Verify the On/Off switch is in the OFF position.
3. Before connecting the MK-370EXP Saw to a power supply, be sure the
voltage, cycle and phase of the job site power source meet the requirements
of the table below.
4. Plug the MK-370EXP Saw into a wall outlet with built-in GFCI protection.
5. Do not cover the motor vents as this could lead to motor overheating.
VOLTAGE 120v
CYCLE 60Hz
PHASE 1-phase
1. If using an extension power cord, make sure the length and wire gauge correspond
to the requirements listed in on page 10. An extension power cord that is too small
in wire gauge (diameter), or too long in length, will cause the motor to overheat and
could cause premature failure.
NOTE:
CAUTION
MK-370EXP SAW SETUP