MK Diamond MK-370 EXP - Manual (Page 32)

32
Like most cutting instruments, a diamond blade performs best when it is dressed. Over time and
use, diamonds on the outer edge of the blade will become smoothed or “glazed" over.
This will reduce grinding efficiency and may cause the blade to “wander" or bend giving the illusion
of an alignment problem. When this occurs, the blade will need to be dressed.
The diamond blade can be dressed using the MK Dressing Stick (part# 152792) and by following
the steps below.
BLADE DRESSING
(B)
Set the Adjustable Cutting
Guide to cut a 1/16-strip
(A)
Setup the MK-370EXP Saw
for operation (See Setup,
Adjustment and Operation)
(C)
Position the Dressing Stick
(E)
Verify cooling flow on both
sides of the blade
(D)
Turn the motor ON
(F)
Cut the Dressing Stick 7 or
8 times to dress the Blade
(G)
Ensure the ON/OFF Switch
is in the OFF position
MK-370EXP SAW MAINTENANCE