MK Diamond MK-370 EXP - Manual (Page 17)

(D)
Install the Height Adjusting Knob
through the Post into the Cutting Head
and tighten the Knob
17
Follow the assembly instructions to prepare your MK-370EXP Saw for operation.
CUTTING HEAD INSTALLATION
(B)
Align Cutting Head Pivot Hole
to the Post, Pivot Shaft
(A)
Place the Flat Washer onto the
Height Adjusting Knob
(C)
Verify the Cutting Head is
completely installed and
seated on the Post
(B)
Loosen the Blade Guard
Retaining Wing nut
(A)
Loosen and remove the
Blade Guard Retaining
Knob
(C)
Open the Blade Guard
DIAMOND BLADE INSTALLATION
When installing the Retaining Screw, do not "cross-thread" and DO NOT over tighten the screw.
MK-370EXP SAW INSTALLATION
NOTE: