MK Diamond MK-370 EXP - Manual (Page 35)

35
If alignment problems are the result of a warped blade, a bent frame or bent support arm,
or, if alignment is off by more than 1/8-inch, contact the MK Diamond Service Center -
(800) 474-5594
(E)
Verify Wheel Assembly side of
Movable Cutting Table height
is same as Guide Bar side
(D)
Move Square to wheel
assembly side of the cutting
table
(F)
If gap exists, loosen Movable
Cutting Table Wheel Assembly
(H)
Check that there is no gap
between the Square and the
wheel assembly side of frame
MOVABLE CUTTING TABLE ALIGNMENT VERIFICATION
This will verify the Movable Cutting Table is aligned to the frame of the saw.
If the blade is misaligned following alignment verification, attempt to align using Alignment
Screw, 90º Verification. The Diamond Blade must be removed and reinstalled when
removing the Blade Guard.
(B)
Place Square on guide bar
side of cutting table
(A)
Remove Blade Guard
(C)
Lock in position
(G)
Move Wheel Assembly up or
down to Square the Movable
Cutting Table
(I)
Tighten Movable Cutting
Table Wheel Assembly
MK-370EXP SAW TROUBLESHOOTING
NOTE: