Lenze EPM−H410 - Manual (Page 94)

Operation
Saving data on the memory card
6
l
94 EDBPM−H410 DE/EN/FR 4.1
6.6 Saving data on the memory card
ƒ You can save and archive your custom−designed configured project on this
memory chip.
ƒ You can mount the memory chip with the saved project in an operating
unit of the same type in order to transfer the project to this operating
unit.
ƒ The following operation is only provided to you if the memory module is
mounted in the operating unit. (
¶ 75)
You want to ... Press keys ... Example
A access the memory card.
l Tansfer page is shown.
shift + Enter H410 TRANSFER PAGE
Graphic controller BOOT check: OK
F1:MSP F2:FlashCARD ENTER:EXIT
Graphic controller RAM check : OK
l Select the Flash Card" menu.
F2
B Select the function.
FlashCARD MENU
Back-Up for: H410
Firmware present
Project
present
F1:BACKUP F2:RESTORE
F3:ERASE F4:EXIT
l BACKUP
– Save project from the operating
unit on the memory chip.
F1
l RESTORE
– Transfer contents of the memory
chip to the operating unit.
F2
l ERASE
– Delete contents of the memory
chip.
F3
l EXIT
– Back to the transfer page.
F4
C Exit the transfer page
Enter H410 TRANSFER PAGE
F1:MSP F2:FlashCARD ENTER:EXIT