Lenze 8400 motec Manual - Manual (Page 25)

Product description
Overview of control terminals
3
l
25 EDS84DG752 EN 4.0
3.5 Overview of control terminals
The control terminals of the 8400 motec controllers are available in the entire system in
two versions:
ƒ Extended or
ƒ Standard.
The control terminals are always located in the Communication Unit.
The type of fieldbus version, power class of the inverter or motor frame size have no
influence on the availability.
Connection options for Communication Unit WU
Plugs X3 X61 X4 X1
Name Fieldbus Safety Digital input/output Analog
input
Relay Holding
brake
Type SIA/SIB RFR DIx DO1 AI/AU COM/NO BD1/BD2
E84DGFCNNNx
NO BUS
(without
fieldbus) − 1 x 2 x − − ь ь
E84DGFCSNNx
Standard I/O
(without
fieldbus) − 1 x 5 x ь ь ь ь
E84DGFCAxNx
ASi
−
1 x 5 x ь
− −
ь
E84DGFCAxJx ь ь ь
E84DGFCCxNx
CAN
− − −
E84DGFCCxJx ь ь ь
E84DGFCGxNx
EtherNet/IP
− − −
E84DGFCGxJx ь ь ь
E84DGFCPxNx
PROFIBUS
− − −
E84DGFCPxJx ь ь ь
E84DGFCRxNx
PROFINET
− − −
E84DGFCRxJx ь ь ь
E84DGFCTxNx
EtherCAT
− − −
E84DGFCTxJx ь ь ь
ь available
−
not available