Leica Biosystems EG1150 C - Manual (Page 8)

8 Instructions for Use V 2.4 RevD – 10/2012
2. Safety
Warnings – Safety notes on the instrument itself
Safety instructions – transport, installation and operation
• After unpacking the instrument it may only be transported in an upright position.
• Before connecting the device to a power source, ensure that the voltage indicated on the
type plate matches the voltage available at the place of installation.
• The unit must be connected only with the supplied power cable and only to a grounded
power receptacle. Do not use an extension cord.
• The power socket to which the instrument is connected has to be near the instrument and
easily accessible.
• This device may only be used by trained laboratory technicians. It must only be operated
for the purpose of its designated use and according to the instructions contained in these
Instructions for Use.
• Safety notes on the instrument itself marked with a warning triangle indicate that the cor-
rect operating instructions (as defined in these Instructions for Use) must be followed when
operating or replacing the item marked. Nonobservance can cause accidents, injuries and/
or damage to the instrument/accessories.
2.2 Warnings
The safety devices installed in this instrument by the manufacturer only constitute the basis
for accident prevention. Operating the instrument safely is, above all, the responsibility of the
owner, as well as the designated personnel who operate, service or clean the instrument.
To ensure trouble-free operation of the instrument, make sure to comply with the following
instructions and warnings.
To prevent damage to the instrument or the specimen, only accessories authorized by
Leica may be used.